| Car window tints offers privacy and UV protection, but | | | | 7: Push the tint below the inner rubber seals of the |
| assess your skills before taking on this project yourself: | | | | window. |
| At the very least, you'd better be good at measuring | | | | 8: Use the card to make sure that the tint goes into all |
| and cutting. This is a precision job but can be done by | | | | the corners. |
| almost everybody. | | | | 9: Take a blow dryer in one hand and a squeegee in |
| Instructions | | | | the other, and heat from the top on one side, working |
| 1: For car window tint in 15 steps you will need the | | | | the tint with the squeegee on the other side in a |
| following tools and materials:tinting film, an X-Acto knife, | | | | horizontal motion. This should get out any remaining |
| razors, a blow dryer or heat gun, 4-inch squeegees, | | | | moisture from between the film and glass.This ensures |
| small sponges, a 4-inch hard card , a bone tool, and a | | | | that the film is cleanly stuck. |
| spray bottle filled with a mixture of dishwashing soap | | | | 10: Use the same system to apply the tint film to the |
| and water. | | | | front window. |
| 2: | | | | 11: Follow steps 3 and 5 in applying the film to the back |
| Cut the film in the shape of the windows. Set cutouts | | | | window. |
| aside on a glass board or an area devoted to cut film. | | | | 12: Count the number of defroster heater lines on the |
| This can be done easily by using the outside of the car | | | | back window. |
| window as a template. | | | | 13: Cut the rear window film into the required number |
| 3: Spray the side window with the soap and water | | | | of panels. |
| mixture. | | | | 14: Place the first panel on the bottom, the second |
| 4: Use a razor to go over the side window to remove | | | | panel on top of the first, the third panel on top of the |
| any residue. | | | | second and so on. Identify the heater line where two |
| 5: Use a 4-inch squeegee to get rid of any residue | | | | panels overlap. |
| from top to bottom. Paste the residue out of the film. | | | | 15: Trim the film from over the defroster lines. |
| 6: Apply the tint to the side window. Leave 1/4 inch to 1 | | | | And there you have it...You have successfully used |
| 16 inch from the top edge of the window without tint. | | | | CAR WINDOW TINT with 15 simple steps to add a |
| This will be covered when the window and door are | | | | whole new feel and look to your car. |
| closed.This step is very important with car window tint | | | | It could not be any easier than this! |
| in 15 steps | | | | |